how to install glue down carpet::With only a few basic tools and suggested steps, you can carpet a room with a bare concrete floor, even if you have little or no experience how to install glue down carpet

how to install glue down carpet

how to install glue down carpet

how to install glue down carpet::With only a few basic tools and suggested steps, you can carpet a room with a bare concrete floor, even if you have little or no experience.
Just follow these 7 simple steps.
Step 1: apply waterproofing paint after sweeping the floor and removing all debris, coat the floor surfac with waterproofing paint.
Allow 24 hours for the paint to dry.
If humidity in the room is high, allow an extra day for drying.
You can speed up drying and at the same time remove paint fumes if you open windows and place a few large fans near the windows to exhaust the air.
Step 2: cover floor with plastic sheeting lay a cover of plastic sheeting over the waterproofed floor.
Use duct tape to seal seams in these sheets, and tape the sheeting to the floor at the edges.
This will help you determine the size of the plywood pieces to be cut.
When all sheets are cut, begin laying them on the plastic, one sheet at a time, until the entire floor is covered with plywood.
Screws should inserted along the edges of the plywood every 12 inches.
Step 5: attach tack strips using your hammer and nails, attach tack strips to the surface of the plywood along the edges of the wall.
Step 6: attach padding cut enough padding to cover the entire floor, then lay the padding in place and staple all padding corners and in the center of each padding piece.
Step 7: lay and attach your carpet lay out your carpet over the padding, keeping about 2 inches of carpet above the edges where wall meets floor.
When the carpet is in place, begin cutting along the edges.
If necessary, use a straightedge to insure that the cuts are straight.
Then, tuck carpet edges into the wallfloor corners and below the botto edge of the baseboard.
Be sure the carpet is pressed down onto the tack strips so that it is gripped by the strip nails.
Use a knee kicker to stretch the carpet on the far side of the room from where you attached the first carpet edge.
Finally, cut the excess carpet away at the edges.
how to install glue down carpet::Carpet tiles are much easier to
install than regular carpets and are easier to clean or replace how to
install glue down carpet